Click “Read More” for detailed wiring instructions for version 2.
For use with the ET02 snow and ice melting controller, the ETOG sensor is designed for embedding in the surface of the outdoor area. The ETOG sensor measures ground temperature and moisture. The ETOG sensor should be installed where the worst snow and ice problems normally occur. The sensor should be embedded in a concrete base on a hard surface with the top of the sensor flush with the surface.
Click “Read More” for detailed wiring instructions for version 2.
Yes, the sensor lead can be extended up to 200 meters using same gauge cable. Total resistance of the sensor cable must not exceed 10 ohms.
To work around your faulty ETOG sensor click “Read More” for details.
In order to determine if your sensor is defective, click “Read More” for details.
The ETOG snow and ice melting ground sensor must be wired to specific terminals inside the ET02 controller. Click “Read More” for details.