Installation

Tire Tracks Installation: How Far Do I Space the Mats?


The proper distance to space the mats should be 5 feet on center or 3ft between mats. Please refer to the installation manual for more details regarding your snowmelt installation.

How Long Can You Extend the Lead on the Snowmelt System?


The maximum length Warmup recommends you can extend your snowmelt systems lead is 90′.

How do I test my system using a Megger (Mega-Ohmmeter)?


The megger is used as a quality control measure to test the insulation resistance to detect any fault in the heater cable jacket. Such leaks cannot be spotted with a regular ohmmeter and help spot any damage to the cable and cable jacket.

How Do You Add a Room using the MyHeating App?


There are two ways to add a Room to your account, which will serve as a way to register your 4iE thermostat to your profile.

The first way is through the my.warmup.com profile and the second way is directly through the MyHeating App.

Can I Install the Relay-25 in the Same Electrical Box with my Thermostat?


Warmup strongly recommends that the relay is installed in a separate single gang box to avoid overheating and interference of other cables. Check with your electrician and refer to your local code for specific installation requirements.

Is GFCI (Ground Fault Circuit Interrupter) Required for Bathrooms?


Thermostats with an internal GFCI including the Warmup 4iE and WUDG will fulfill this requirement. If a non-GFCI thermostat like our Tempo thermostat is being used, a GFCI breaker will be required. Consult with your local electrician to make sure your installation is properly protected and meets National and Local Electrical Code.

Can the ETOG Sensor Lead be Extended?


Yes, the sensor lead can be extended up to 200 meters using same gauge cable. Total resistance of the sensor cable must not exceed 10 ohms.

Can I Install my Floor Heat over an Existing Sheet of Vinyl Floor?


If using a DCM-PRO membrane, scrape/scratch and prime the vinyl to ensure bonding with a highly modified thinset and install the membrane directly to it.

Conduit Requirements when Installing a Warmup System


We recommend using a conduit 1/2 conduit for one lead or a 3/4″ conduit if connecting two systems to one thermostat. In addition, we recommend a separate 1/2″ conduit for the floor sensor.

How Do I Mount a Warmup Towel Warmer?


This post explains how to mount and position your Towel Warmer properly in your space.

Get a Quote
Scroll to Top
This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.