System Power is requested during the initial setup of your device. System power is simply the wattage of the heating system that you connect to your thermostat. To set your systems power select the following: menu > energy monitor > power settings > select the wattage using the up and down arrows > accept.
Then you will select the days of the week you would like to program to apply for, press ‘accept’ and then add periods of times you would like the system to be on and heating. The following menu will allow you to set times and temperatures. Lock in your program by pressing accept twice.
First, the device number shows up during the initial startup menu and recommends the number be written down. Secondly, it can always be accessed afterwards on the device itself.
The Warmup SmartGeo is a way to allow your thermostat to combine the location settings on your device, occupancy sensing features and a few algorithms to create the most comfortable heat as efficiently as possible.
Once your profile and 4iE are registered, you can now set up or edit a program through the MyHeating App. Note: You can set multiple different programs for different days. Refer the the video below for further guidance.
There are two ways to add a Room to your account, which will serve as a way to register your 4iE thermostat to your profile.
The first way is through the my.warmup.com profile and the second way is directly through the MyHeating App.
This page outlines the recommended installation methods for your installing your sensor probe.
The cold tail lead and the sensor probe should be run in separate conduits. This will prevent any interference from the cold tail lead affecting the temperature readings from the sensor probe.
This is a summary of the recommended installation practices when installing asphalt over a Warmup heated driveway system.
Short video showing the installation of Warmup Snow Melting Mat installed on an asphalt driveway.
