Home / Picture / Loose Wire – NADWS
Why does my floor get warmer in some spots?
Loose Wire – NADWS
Your floor can reach higher temperatures in some areas where furniture, area rugs, dog beds or other fixtures are trapping the heat. Avoid placing thick mats, rugs and floor level furniture on your heated floor, specifically in the area where the sensor probe is located. These restrict the transfer of heat away from the cables and result in the floor area beneath them being warmer than other areas.
Warmer spots can also be caused if wire spacing is closer in some parts than others. Make sure the wire is spaced consistently at the time of installation.
Further Questions?
-
Installation
- What are the electrical requirements for my Warmup system?
- Why does my floor heat unevenly?
- Why does my floor get warmer in some spots?
- How do I check if the cable is working ?
- Can I install directly onto durock or hardieboard?
- The Factory Joint Rule
- Can I install my Warmup system directly on top of plywood ?
- Can a wooden floating floor be installed directly over the Warmup NADWS system?
- What do I need to prepare for my electric floor heating project?
- Specialized installation – under Nailed Hardwood
- Floor Heating Loose Wire Installation Video
- If I have too much mat or cable, can I cut it?
- Can I cross floor heating cables?
- How long after flooring installation should we wait to use the heat?
- Can you install over tile?
- How do I register a product warranty?
- Can I install directly onto durock or hardieboard?
- Does Warmup restrict tile size?
- What can I do if I do not have enough cable?
- How do I test my heating cable(s)?
- Comment tester mon (mes) câble(s) chauffant(s) ?
- What is the difference between a Watch Dog and an Alligator?
- Can I install a wooden floating floor directly on top of the cable ?
- Can the cold tail lead of your Warmup indoor heating system be extended?
-
Troubleshooting
- What are the electrical requirements for my Warmup system?
- Should I use Self-leveler or Thinset ?
- Is it Normal if my Thermostat Makes a Clicking Noise?
- Can I Cut the Electric Floor Heating System Wire if I Have too Much?
- Can I have a technician come to my home?
- How does the infrared thermal camera work?
- How do I test my heating cable(s)?
- Comment tester mon (mes) câble(s) chauffant(s) ?
- What is the difference between a Watch Dog and an Alligator?
- How to Check the Resistance Readings of your Electric Floor Heating System
-
Miscellaneous questions
- Why does my floor heat unevenly?
- Why does my floor get warmer in some spots?
- The Factory Joint Rule
- Can I use an uncoupling membrane with the NADWS cable ?
- Can I install my Warmup system directly on top of plywood ?
- Can a wooden floating floor be installed directly over the Warmup NADWS system?
- How Long will my Electric Floor Heating System Take to Heat Up?
- Can I Cut the Electric Floor Heating System Wire if I Have too Much?
- What is the EMF level of Warmup cables?
- Should I use a 120V or 240V electric floor heating system?
- Can I use area rugs with underfloor heating?
- How much does underfloor heating cost to operate?
-
Preparing for your project
- What do I need to prepare for my electric floor heating project?
- How Long will my Electric Floor Heating System Take to Heat Up?
- Should I use Self-leveler or Thinset ?
- Can I install floor heat under my tub?
- What product do I use if I need 110V?
- Can floor heating be used as a primary heat source?
- Can I heat under furniture?
- How do Floor Heating Systems Work?
- Calculating Heat Loss: How many BTU’s are in a watt?
-
Wiring
- What is the EMF level of Warmup cables?
- Should I use a 120V or 240V electric floor heating system?
- Is the electric floor heating system wired correctly?
- If I have too much mat or cable, can I cut it?
- Can you wire floor heat for 120 or 240 volt?
- What gauge wire should be used?
- What is the difference between a Watch Dog and an Alligator?
- How to Check the Resistance Readings of your Electric Floor Heating System