You can stick the insulation boards to the concrete slab using regular modified or pre-mixed thin set. We recommend a 1/4 x 1/4” trowel.
Do I need to prime my subfloor before installing Ultralight? Read More »
You can stick the insulation boards to the concrete slab using regular modified or pre-mixed thin set. We recommend a 1/4 x 1/4” trowel.
How do you stick the insulation boards to the concrete slab ? Read More »
Layering Ultralight Insulation Boards: Is it Possible? Ultralight cannot be layered because the thickness will double of amount of movement under the tile which means the floor will not meet the declared wear ratings. Pro Tip: If you need more height, use leveler to prepare the floor as needed followed by Ultralight. More
Can multiple layers of Ultralight be installed? Read More »
You can stick the insulation boards to the concrete slab using regular modified or pre-mixed thin set. We recommend a 1/4 x 1/4” trowel.
How Big and How Heavy are Ultralight Boards? Read More »
There is a specific way to install the insulation boards over a wooden sub-floor. Click “Read More” to learn how.
Installing insulation boards over a Wooden Subfloor Read More »
See just how easy it is to install our floor heating insulation boards. Click here to watch.
Warmup Insulation Board Installation Video Read More »
All surfaces should be thoroughly cleaned of all dirt and debris. When installing over an existing concrete base, it is important to remove all traces of existing finishes, contamination, etc. to allow for a clean surface.
Insulation Boards: Preparing for the Installation of Floor Heating Read More »
When installing over cement, screws and washers are not necessary. You will first use a trowel to put down a modified mortar. Then you will stagger the boards and press them together.
Installing insulation boards over a Concrete Subfloor Read More »
It is vital that the floor heating thermostat’s floor probe was not only installed but done so the right way. Click “Read More” for details.
For thicker pour of up to 6”, elevate the wire mesh on which the cable is tied with bricks, wood blocks or other spacers to float the cable at the desired level. Depending on the construction of the subfloor and in general, in order to improve the efficiency of the system, you may need to apply insulation prior to the pour.
Basic Installation of the In-slab Floor Heating Cable Read More »
