System Power is requested during the initial setup of your device. System power is simply the wattage of the heating system that you connect to your thermostat. To set your systems power select the following: menu > energy monitor > power settings > select the wattage using the up and down arrows > accept.
What is System Power on my 4iE and how can I edit it? Read More »
Then you will select the days of the week you would like to program to apply for, press ‘accept’ and then add periods of times you would like the system to be on and heating. The following menu will allow you to set times and temperatures. Lock in your program by pressing accept twice.
How do I Set a Custom Program on my 4iE? Read More »
First, the device number shows up during the initial startup menu and recommends the number be written down. Secondly, it can always be accessed afterwards on the device itself.
Where Do I Find my 4iE’s Device Number? Read More »
The Warmup SmartGeo is a way to allow your thermostat to combine the location settings on your device, occupancy sensing features and a few algorithms to create the most comfortable heat as efficiently as possible.
How Do I Enable to SmartGeo Feature on the MyHeating App? Read More »
Once your profile and 4iE are registered, you can now set up or edit a program through the MyHeating App. Note: You can set multiple different programs for different days. Refer the the video below for further guidance.
How to Set Up a Program using the MyHeating App? Read More »
There are two ways to add a Room to your account, which will serve as a way to register your 4iE thermostat to your profile.
The first way is through the my.warmup.com profile and the second way is directly through the MyHeating App.
How Do You Add a Room using the MyHeating App? Read More »
Warmup strongly recommends that the relay is installed in a separate single gang box to avoid overheating and interference of other cables. Check with your electrician and refer to your local code for specific installation requirements.
Can I Install the Relay-25 in the Same Electrical Box with my Thermostat? Read More »
Thermostats with an internal GFCI including the Warmup 4iE and WUDG will fulfill this requirement. If a non-GFCI thermostat like our Tempo thermostat is being used, a GFCI breaker will be required. Consult with your local electrician to make sure your installation is properly protected and meets National and Local Electrical Code.
Is GFCI (Ground Fault Circuit Interrupter) Required for Bathrooms? Read More »
There is no battery backup or capacitor in the 4iE, however, there is internal memory. Periodically the programming and date/time are stamped to a section of internal memory. This is then overwritten when the next stamp takes place. When the power is resumed following a power outage, the device will revert to the most recent stamp taken.
Does the 4iE have a Battery Backup? Read More »
You can opt into using the air probe instead of the floor probe if you are more concerned about trying to achieve a specific air temperature, usually for primary heat.
When Should I Select Air vs. Floor when Programming my 4iE Thermostat? Read More »
