Heater error will occur if the heating system is not properly wired to the thermostat. Please click “Read More” for details.
Heater Error: What Does it Mean if my Thermostat Reads “Heater Error” on the Display? Read More »
“Draw an installation plan showing the placement of the mats, floor sensor, and lead wire(s) to the thermostat. The Warmup Foil heating system should be at least 6″” away from walls for laminate and 12″” away for carpet. “
General installation notes for the Foil Heating System Read More »
What do you do when this message appears on your UCCG floor heating thermostat? Click “Read More” for details.
Error Message E2 – UCCG floor heating thermostat Read More »
Ground Fault protection is a must, especially with bathroom and other “wet” installations. Are you covered? Click “Read More” for the answer.
Does the TH115 Floor Heating Thermostat have GFCI Built In? Read More »
For tips for connecting and programming your system click “Read More”.
Connecting Your Foil Heating System Read More »
Ensure you have created your account and registered the thermostat using the Device Number. Click “Read More” for details.
Connected to the internet and getting the 4iE ! message? Read More »
This page explains why Warmup does not recommend you cut the wire for any reason and provides solutions to having too much cable.
Can I Cut the Electric Floor Heating System Wire if I Have too Much? Read More »
Instead, try pulling the cable off the mesh and spacing the cable every 2 or 2.5 inches apart. Consult your installation manual with further questions regarding where the cable or mat can be run.
Can I cut my floor heating mat if it’s too large? Read More »
That “Ground Fault” error on your thermostat after several years could indicate your floor heating system had been damaged during installation. Click “Read More” to learn why.
Are you getting a “Ground Fault” error after a few years? Read More »
The “ER1 Out” error on a 3iE Thermostat indicates that the thermostat is not set up correctly. Click “Read More” for details.
“ER1 Out” Thermostat Reading on the 3iE Display Read More »
